EDM-1 Chassis:
Any gearbox style chassis using 4 wheel independent suspension is legal - Buggy based conversions also
are legal & maybe be altered to reverse Gearboxes & offset batteries.
Gearboxes must be of 3 internal gear configuration - No Direct Drive Permitted
EDM-1A Wheelbase to be: Min. = 9", Max = 11.5" Max. Track Width = 9.875" (9 7/8")
EDM-1B Overall Length - Including Body: Max. 22"
EDM-1C Weight to be 54oz (3lbs-6oz or 3.38lbs) Minimum
EDM-2 Motors:
EDM-2A MOTORS:  The ONLY Motors which will be Legal for the Hooter Chassis Outlaw Tour will be the Trinity 
Monster, Cobalt & X-Stock, Stock Motors. NO OTHER Motors will be permitted throughout the entire 
2008 - 2009 Race Series regardless of any new ROAR legal qualifications.  These are locked timing (tab must 
be present), 27 turn - 24 degree timing, rebuildable motors. NO BEARINGS PERMITTED
All endbell hardware must be stock & may not be altered in any way.  (spring posts may be swapped) 
EDM-3 Tires: 
EDM-3A Wheel width to be Max. 1.75" (buggy wheels) - Foam Tires ONLY
EDM-3B Pan Car wheels are permitted but must be cut down to a max width of 1.5"
EDM-4 Batteries:
EDM-4A 5000mahr capacity will be the max allowable throughout the entire Hooter Chassis Outlaw Tour 
Series regardless of any new ROAR legal qualifications.
EDM-4B Batteries to be 6-cell packs.
EDM-5 Body:
EDM-5A Modified bodies only permitted - must leave front wheels completely exposed & rear tires must be at least 1/3
exposed. Bodies based on replicating Big / Small Block Modified Cars not E-Mod style cars
EDM-5B Body to be realistically painted - side windows to be transparent & present of rear quarter window also must 
be clear. Hooter Chassis Tour Sticker must be placed on the top area.
EDM-5C Center of body must be open - no front sealed window to act as spoiler 
EDM-5D An additional front panel is allowed on the front of the car but may not extend past the front bumper & be no 
wider than 4.5"
EDM-5E No additional lips or flaps / spoilers are permitted with the exception of a 1/4" bend at the rear of the roof & 
top & bottom of the side & sail panel - no more than 45 degree's.
EDM-5F Max. Roof Height = 7.0" - at any point DRAWING TO BE ATTACHED SHOWING DIMENSIONS FOR INSPECTION
"Items Highlighted in Yellow & Boxed In Red"
Min. Roof Height = 6.5"
EDM-5G Max. Body Width = 8"
Min. Body Width = 7"
EDM-5H Rear spoiler cord = Max. 3"
EDM-5I Max. Side / Sail Panel Length = 17" - Side Panels May Not Extend Past The Front Axle
EDM-5J Additional modified nerf bars & rear bumpers are permitted - side bars not to extend past body more than 1/4",
rear bumper should not extend out past the end of the body.
EDM-5K Front bumpers are permitted - they must be flat (not angled to act as wing / spoiler) - Max. width to be 5".